Decking MTWOOD 145x25

Normal technical warranty terms for 3D plastic wood within 1 year include:

1. Product quality warranty: The manufacturer commits that plastic wood products are manufactured with high quality and comply with technical standards. Within 1 year, if any defects appear due to manufacturing errors or unsatisfactory quality, the manufacturer will be responsible for repairing or replacing the product.
2. Anti-rot and anti-mold warranty: Plastic wood is warranted not to rot or be affected by mold for 1 year. If the product has any problems related to rot or mold during the warranty period, the manufacturer will repair or replace the product.
3. Warranty against fading: Plastic wood is warranted against fading due to sunlight for 1 year. If the product exhibits discoloration during the warranty period, the manufacturer will repair or replace the product.
4. Warranty against warping and cracking: Plastic wood is warranted against warping or cracking due to weather effects for 1 year. If there are any problems related to warping or cracking during the warranty period, the manufacturer will repair or replace the product.
5. Warranty conditions: Warranty only applies when the product is used and stored properly according to the manufacturer's instructions. The warranty does not apply to cases of misuse, improper use, or impacts from external causes such as accidents, natural disasters, or use of inappropriate materials.

Note that specific warranty terms may vary depending on the specific manufacturer and product. All detailed warranties will be provided in the manufacturer's documentation or warranty policy.

When constructing beam spacing equal to or shorter than 300mm and plastic wood frames of the same type, there are some important notes as follows:

1. Prepare the correct size: Ensure that plastic wood bones of the same type are cut and prepared to the correct size to ensure accuracy and uniformity during construction.
2. Make sure beam distance =< 300mm: Measure and mark beam distance =<300mm on the surface where you plan to install plastic wood bones. Use precision measuring tools to ensure these distances are regular and accurate.
3. Use the right tools: Make sure to use the right tools to install plastic wood bones. Cutting and drilling tools must be sharp and suitable for the material, helping to minimize damage and produce the best results.
4. Check and adjust: Before installing plastic wood bones, check and adjust the dimensions and position to ensure accuracy and uniformity. This helps avoid errors and corrections later.
5. Use appropriate mounting methods: For spacing =< 300mm, mounting methods such as screws, nails or clamps can be used to keep the plastic wood bones fixed and sturdy.
6. Maintenance and cleaning: After completing the installation, maintain and clean the plastic wood bones regularly to maintain its durability and appearance. Use appropriate cleaning products and follow the manufacturer's instructions.

Remember to follow the manufacturer's regulations and instructions when constructing beam spacing =<  300mm and plastic wood bones of the same type to ensure the best and safe results.